RGBLink VSP 1314 User Manual - Manual (Page 62)

5.System Setup and Operation
How to splicing with DVI3
VSP 1314 User Manual 62
How to splicing with DVI3
Make sure equipment normal operation. Detail please refer to : How to
make equipment normal operation
Splicing:
VSP1314 also is a seamless switcher. As a switcher use the DVI3 to input
signal. The max resolution of switcher is twice of DVI3 input, output
interface is DVI1 output and DVI2 output, and preview DVI3 signal via
output VGA; There are transverse and vertical splicing; Such as DVI3 input
is1920x1080，so can splicing 3840x1080 or 1920x2160.
Operation as following:
1.Press and light up green;
2.LCD shows MENU mode, rotate the adjust knob to select Splicing;
3.Press the adjust knob to ensure and enter it;
4.Press the adjust knob to select switch, ratote to open it;
5. Press the adjust knob then rotate it to select Split Mode. Press the adjust
knob then rotate it to select Split Mode. There are three kinds of split
mode: Through、H1/2、V1/2;
Input
Output
Split
View
Split Switch： ON
Split Mode： Through
Split Output Channel: DVI1
Display Width： 1024
Split Switch： OFF
Split Mode： Through
Split Output Channel: DVI1
Display Width： 1024