RGBLink VSP 1314 User Manual - Manual (Page 60)

5.System Setup and Operation
How to set DVI3 as background
VSP 1314 User Manual 60
How to set DVI3 as background
Make sure equipment normal operation. Detail please refer to : How to
make equipment normal operation
Operation description:
The system default background for test pattern. There are two ways to use
background: One is to use own test pattern, anther one is to use DVI3 input
signal; It must make sure the input resolution of DVI3 is the same with
equipment before set DVI3 as background;
Operation step as following:
1.Press and light up green;
2.LCD shows MENU mode, press the adjust knob to select Input
3.Press the adjust knob to ensure to enter it; Rotate the adjust knob to
select Matrix;
4.Press to ensure and enter Matrix;Press the adjust knob to select Channel
3 and press to ensure.If DVI3 signal is effective and the output resolution
is the same with equipment, LCD will show input success if not will show
Error information!
Input
Output
Split
View
Input Format
Input Matrix
Channel 1： Input 1
Channel 2： Input 2
Channel 3： Test Pattern