RGBLink VSP 1314 User Manual - Manual (Page 55)

5.System Setup and Operation
How to switch signal of single image
VSP 1314 User Manual 55
How to switch signal of single image
Make sure equipment normal operation. Detail please refer to: How to make
equipment normal operation
Operation as following:
Layer 1 is the program output signal source from DVI. Now DVI light up
green light, and the other signal button are light out that at the same layer,
can ’t to be selected; If need to switch program input signal, can select
signal button of other layer arbitrarily；When DVI2 light up yellow light, it
means DVI2 output to Preview, other signal button light up red light, user
according to the need to select the button and light up yellow light ,Press
TAKE to switch the selected signal to Program output.
Operation as following:
Operation schematic diagram1：
Operation schematic diagram2：
VSP 1314 support display 3 layers :
Layer 1 including:CV1,CV2,USB1,DVI1,VGA1 ,
Layer 2 including:CV3,CV4,USB2,DVI2,VGA2 ,
Layer 3 is background input, user can set DVI3 as background signal or as
test pattern.