REMKO GPM - Manual (Page 23)

23
Pivoting wall installation
The instructions for installation of
the pivoting brackets are included
with the packaging.
The use of pivoting brackets is
appropriate for the following
cases:
a) Installation of the unit in a
corner
b) Installation of the unit at a right
angle to the wall it is mounted
on
c) Installation of the unit on a
column
Standard wall installation
Align the wall brackets in a
suitable place on the wall (spirit
level) and securely fasten. Mark
the boreholes to be made with a
pencil.
- Securely attach the wall brackets
with suitable anchors and screws
- M10 or greater.
- Install the two bracket pairs with
the supplied material as shown in
the figure
- When installing the brackets,
lock the nuts with a locking ring
between the bracket and nut.
- Position the unit on the brackets
so that the holes of the unit line
up with those of the brackets,
whereby the corners of the
brackets must be flush with the
front edge of the unit (except for
GPM 75).
- Fasten the equipment with the
M8 screws provided; in the
process, insert a locking ring
between the screw and bracket.
Computerised part no.: 228760
Brackets for wall installation
(standard design) GPM 15 - 75
The units may only be
mounted on stable walls,
ceilings or structures made of
non-flammable construction
materials with sufficient
bearing capacity.
ATTENTION
We reserve the right to modify the dimensions and constructional design as part of the ongoing technical development process.
The brackets must be
connected to the unit and the
wall in a de-energised state.
NOTE
Make sure that the type of
anchor and size of the screws
are appropriate for the type of
masonry in order to bear the
weight of the unit.
NOTE