REMKO GPM User Manual

Page 19

Automatic operation

The ventilation phase can also be
operated automatically, where a
weekly time programming is set, as
described for heating.
For use of the automatic
operation, the SAN value must be
set to mode 2 instead of 1. See the
previous page for the procedure.

Then, to switch on the ventilation
automatically, carry out the
following steps: Press KM and
page 1 is shown on the display,
where the following options are
possible:

HTG SAN

INFO >>

Press key K1 (HTG) and the
following display appears:

AUTO ON

OFF

TIME

Switch off the heating phase by
pressing K3 (OFF).
After pressing the button, the main
display appears again with the
initial settings on the display.
Press KM again and page 1 is
shown on the display, where the
following options are possible:

HTG SAN

INFO >>

All 21 TSP parameters can be
called up with the keys K1 and
K4; use the keys K+ and K- of the
electronic temperature regulation
to change the values.

After successfully changing the
values, you can leave the settings
by pressing KM for 8-10 seconds.

Ventilation (summer)

The ventilation mode can be
adjusted in both AUTOMATIC and
MANUAL operation.
In both cases the TSP value A35
(PARAM K 10) of the electronic
temperature regulation must first
be set to 1.

For adjustment of the ventilation
function, the SAN value must then
be set to the respective operation
mode.
In doing so, proceed as follows:
Press KM and page 1 is shown on
the display, where the following
options are possible:

HTG SAN

INFO >>

With key K4 (>>) you arrive at
page 2 of the menu, where the
following options are possible:

PROG REG

TIME >>

In the SAN operating phase
the unit can be used in both
automatic and manual ON
OFF operation.

NOTE

To change the TSP value,
proceed as described with the
room correction mode.

NOTE

Press key K2 (REG) and then
K4 (>>) and call up the values
successively until the following
display appears:

PROG SAN

With the keys K+ and K-, enter the
SAN value according to the desired
operation mode:
1 = Manual operation
2 = Automatic operation

After changing the value, wait a
few seconds until the numerical
value flashes.
In this way the successful entry of
the value is confirmed.
Finally, press KM in order to leave
the menu.

Manual operation

To switch on the ventilation
manually, carry out the following
steps: Press KM and page 1 is
shown on the display, where the
following options are possible:

HTG SAN

INFO >>

Press K2 (SAN) in order to arrive at
the following menu:

OFF

TIME

K2 (ON) or K3 (OFF) can be
pressed in order to either switch
the ventilators on or off, in which
the manual ventilation operation is
activated.