Remko gpm – REMKO GPM User Manual

Page 20

REMKO GPM

By pressing K1 (-), K2 (T1) or K3
(T2) the desired parameter that
should be adjusted to the required
time period is selected; the menu
automatically returns to the display
of the SAN programming mode.

Use the keys K+ and K- in order
to call up the times successively, as
described with the heating phase.

The times set for one day can also
be copied for all other days with
the button K3 (COP).

Press KM in order to leave the
menu and return to the initial
settings.

After setting the calendar, proceed
as follow for activation of the
automatic heating:

Press KM and page 1 is shown on
the display, where the following
options are possible:

HTG SAN

INFO >>

Press key K2 (SAN) until the
following display appears:

AUTO ON

OFF

TIME

Press key K1 (AUTO). The display
returns to the initial display and
the operation mode is set to
automatic operation.

The timer can only be
adjusted by half hour
intervals. No minute
values can be entered
(e.g. 8:00-10:30, but not
7:43-20:15).

NOTE

With automatic settings with
heating switched on, the
times set for this operation
cannot be displayed during
the ventilation phase.

NOTE

In both automatic and manual
operation the symbol of a
water tap appears on the
main display when only the
ventilation phase is activated.

ATTENTION

The unit does not conduct
secondary ventilation; it
switches off at the adjusted
time.

For deactivation of the automatic
operation, proceed as follows:

Press KM and page 1 is shown on
the display, where the following
options are possible:

HTG SAN

INFO >>

Press key K2 (SAN) until the
following display appears:

AUTO ON

OFF

TIME

Switch off automatic ventilation by
pressing K3 (OFF).

With key K4 (>>) you arrive at
page 2 of the menu, where the
the following options are possible:

PROG REG

TIME >>

Press key K1 (PROG). Then the
display shows:

HTG SAN
K1

By pressing key K2 (SAN) you can
display the menu for selection of
the operating conditions for SAN:

DAY

REG

COP PRE

Here, the daily times and the week
calendar (DAY) can be
adjusted.

The programming settings (button
K2 - (REG)), where the following
can be selected, are:

1) - Programming is not changed
2) - T1 SAN mode is excluded
3) - T2 SAN mode is released