REMKO ML 262 DC Arctic - Manual (Page 7)

30 minute intervals within the
following 24 hours.
"TIMER OFF" button
This button serves to program
the automatic shut-off time
in 0.5 h intervals within the
following 24 hours.
"RESET" button
This button resets the remote
control to its factory default
configuration.
"TURBO" button
The TURBO function activates
the maximum fan speed and
the compressor.
"Lock" button
This button can be used to lock
the remote control's keys. An
unintentional adjustment can
be prevented.
"LED DISPLAY" button
This button switches the display
on and off (no influence on
unit function)
“FP” button
This button activates the “frost
protection function”, which
sets the nominal temperature
in heating mode to 6°C. This
function is used to guaranteed
frost protection in unsupervised
rooms. When the FP function
is active, the device switches
heating mode on and at 10°C
switches it off again.
This serves to ensure that
the frost protection limit is
not reached. If “FP” mode is
activated, this is indicated in the
display.
Pressing “ON/OFF”,”MODE”,
“FAN”, “TEMP
▲ ▼ “TIMER
ON/OFF”, FP” will quit the
function.
2. Cooling mode
In this mode, the warm room
air is cooled to the
desired temperature.
3. Dehumidification mode
In this mode
the room is mainly dehumidified
and the adjusted temperature is
maintained.
4. Heating mode
In this mode, the warm air in
the room is heated up to the
desired temperature.
5. Circulation mode
In this mode, the air in the
room is circulated with no
change in temperature.
"FAN" button
Press this button to set the
desired fan speed. 4 speeds
are available: Automatic, high,
medium and low fan speed.
"AIR DIRECTION" button
This button sets the desired
fin position of the exhaust
fins. Various fixed positions
and an oscillating function are
available.
Button "SLEEP"
After pressing this button,
the target temperature in
cooling mode automatically
increases by 1 °C within one
hour. In heating mode, the
target temperature is reduced
by 1 °C within one hour.
"SWING" button
This button directly activates
the oscillating function of the
fins for better air distribution in
the room.
"TIMER ON" button
This button is used to
program the time at which the
unit is automatically activated in
Buttons on the remote control
"ON/OFF" Button
Press this button
to start the unit.
" ▼ " button
This button is used to
reduce the desired temperature
to as low as 17 °C.
" ▲ " button
This button is used to
increase the desired
temperature
to up to 30 °C.
"MODE" button
Use this button to
select the operating mode.
The indoor unit has 4 modes:
1. Automatic mode
In this mode, the unit works in
cooling or in heating mode.
Buttons on the remote control
7