REMKO ML 262 DC Arctic - Manual (Page 6)

Display on indoor unit
The display illuminates according to the settings.
v Display on indoor unit
Timer Automatic mode Operation
Display
Display of coded
error messages,
room and target
temperature
Defrosting
mode
Operation
Infrared remote control
The infrared remote control sends
the programmed settings over
a distance of up to 6 m to the
receiver of the indoor unit. Data
will only be received correctly if the
remote control is pointed at the
receiver and no objects obstruct
the transmission path.
First insert the batteries supplied
at delivery (2 x type AAA) into
the remote control. To do so,
remove the cover of the battery
compartment and insert the
batteries as indicated according to
their polarisation (see markings).
The indoor unit is easily operated using the standard infrared remote control. The indoor unit beeps to
acknowledge the correct transmission of data. If it is not possible to program the indoor unit using the remote
control, it can also be manually operated.
Faults are shown in code
(See chapter fault remedy and
customer service)
CAUTION
Replace discharged batteries
immediately with a new set in
order to avoid the danger of
leakage.
It is recommended that the
batteries are removed if the
equipment is shut down for
longer periods.
NOTE
Manual operation
The indoor units can commissioned
manually. After the air inlet screen
has been opened, the inner
recessed button can be pressed
and automatic mode can be
activated.
In manual operation, the following
settings apply:
Cooling mode: last setting
Fan speed AUTO
Heating mode: last setting
Fan: AUTO
Press the button on the infra-red
remote control to interrupt manual
operation.
max. 6 m
Max. distance 6 m
REMKO ML...DC - ARCTIC
6