REMKO ML 262 DC Arctic - Manual (Page 13)

Cleaning the condensation
pump (accessories)
An optional integrated or separate
condensation pump may be
included with the indoor unit,
which pumps out any accumulated
condensation into higher
positioned drains.
Observe the care and maintenance
instructions given in the separate
operating instruction manual.
Type of task
Checks/Maintenance/Inspections
Commissioning Monthly Six-monthly Yearly
General
• •
Measure voltage and current
• •
Check function of compressor/fans • •
Check fan function
• •
Dirt on condenser/vaporiser
• •
Check refrigerant fill quantity • •
Check condensation drain
• •
Test insulation
• •
Check moving parts • •
Sealing test for refrigerant circuit • •
1)
Cleaning the housing of the
indoor unit
1. Disconnect the supply voltage
to the equipment.
2. Open and fold the air inlet
guard on the front side
upwards.
3. Clean the guard and cover
using a soft, damp cloth.
4. Switch the supply voltage back on.
Air filter for indoor unit
Clean the air filter at intervals of
no more than 2 weeks. Reduce this
interval in case of heavily soiled air.
Cleaning the filter
of the indoor unit
1. Disconnect the supply voltage
to the equipment.
2. Open the front side of the
device by folding the guard
upwards and allowing it to
engage (figure 1).
3. Raise the filter and pull it out
pulling downwards.
4. Clean the filter with a standard
vacuum cleaner. Turn the dirty
side upward (figure 2).
5. Dirt can also be removed
by carefully cleaning with
lukewarm water and mild
cleaning agents. Turn the dirty
side downwards(figure 3).
2 Cleaning using a vacuum cleaner
3 Cleaning with lukewarm water
6. If water is used, let the filter dry
out before replacing it in the
unit.
7. Carefully insert the filter. Make
sure it is seated correctly.
8. Close the front side as
described above in reverse
order.
9. Switch the supply voltage back
on.
10. Switch the unit on again.
1 Fold the guard upwards
1) see note
13