REMKO ML 262 DC Arctic - Manual (Page 10)

HEATING Mode
DEHUMIDIFICATION MODE
FAN
Speed
FAN
Speed
FAN
Speed
SWING Button
It is recommended that the target temperature be set to 24 ° in
dehumidifying mode. Due to the low temperature of the refrigerant, the
dew point of the air at the condenser is undercut. The excess moisture
in the air is condensed by the vaporiser, the room is dehumidified.
The fan speed is permanently set to the lowest setting in order to achieve
a maximum level of dehumidification. The compressor switches on and
off in intervals between 17°C and 24°C.
DEHUMIFICATION
MODE MODE
In the heating mode, you can heat the room in spring or fall. The selected
room temperature is set using the
▲/▼ buttons in 1 °C increments. If
the room temperature is 1 °C below the selected target temperature, the
indoor unit starts to heat the air in the room. If the set room temperature
is exceeded by approx. 1 °C, the controller will switch off the heater
function. To protect the compressor, the controller will wait 3 minutes
before switching on the heating mode again.
MODE
HEATING
OPERATION
The air discharge fins are individually adjusted using this button.
Various positions and an oscillating function can be selected.
AIR DIRECTION Button
The oscillating function of the air discharge fins can be adjusted with this
button. This makes it possible to switch directly between a preset position
and the oscillating function. The air distribution in the room is improved
using the swing function.
The fan speed can be adjusted with this button. A selection can be made
between low, medium, high and automatic fan speed.
FAN SPEED Button
FAN
Speed
Automatic High Medium Low
REMKO ML...DC - ARCTIC
10