REMKO ML 262 DC Arctic - Manual (Page 21)

Connecting the outdoor
component
Proceed as follows to connect the
cable:
1. Remove the plastic panel at the
connector.
2. Select the cable cross-section
according to the relevant
standards.
3. Feed both cables through the
edge protection rings on the
fixed connection panel.
4. Connect the cables as shown
on the electrical connection
diagram.
Electrical connection diagram
Connection ML 262 DC to ML 522 DC
Check all plugged and clamped
terminals to verify they are
seated correctly and make
a permanent contact. Tighten
as required.
ATTENTION
5. Anchor the cable in the strain
relief and re-assemble the unit.
(figure 12)
.
12 Connecting the outdoor component
Connecting the indoor
unit
Make the connection as follows:
1. Open the air intake grill.
2. Loosen the cover to the
terminal strip on the right side.
(figure 11)
.
3. Connect the unit to the
control cable from the outdoor
component. See electrical
connection diagram.
4. Re-assemble the unit.
11 Connecting the indoor unit
Outdoor
component Indoor unit Mains cable
Neutral conductor
Exterior conductor
Earth conductor
230 V~,
50 Hz,
L1 / N / PE
Data cable
L1
S S
N N
L1
Indoor unit
21
Control cable and
voltage supply to
the outdoor unit
Cover
Terminal strip