REMKO ML 262 DC Arctic - Manual (Page 5)

Equipment description
The equipment is shipped in
in sturdy transport packaging.
Immediately check the equipment
on delivery and make note of
any damage or missing parts
on the delivery note and inform
the forwarding agent and your
contractual partner.
No warranty can be assumed for
later claims.
Transport and
Packaging
Refrigerant circuit diagram for the indoor unit
Vaporiser fan
Connection to
suction pipe
Connection to injection line
Vaporiser
The connection between the indoor unit and the outdoor component is
made by way of the refrigerant lines.
Outdoor
component
System configuration
Injection line
Indoor unit
Indoor area
Outdoor area
Stop valve
Condenser fan
Condensation line
Suction line
Condensation line
Control line
Mains cable
M
M
Refrigerant circuit diagram for the outdoor component
Condenser fan
Connection valve
Suction line
Connection valve
Injection line
Compressor
Capillary tube throttle element Filter dryer Condenser
Reverse flow valve
Connection
Manometer
The ML 262-522DC room air
conditioning units have a REMKO
ML...DC AT outdoor component as
well as an ML...DC IT indoor unit.
When in cooling mode, the
outdoor component serves to
release the heat extracted by the
indoor unit from the room being
cooled. When in heating mode,
the heat absorbed by the outdoor
component can be released by
the indoor unit into the room
being heated. In both operating
modes, the performance of the
compressor adjusts itself precisely
to the demand, thereby regulating
the target temperature with minimal
temperature fluctuations. This
"inverter-technology" results in
energy savings over conventional
split systems and also reduces noise
emissions to a particularly low level.
The outdoor component can
be installed outdoors or indoors
providing that certain requirements
are met. The indoor unit is designed
to be mounted high up on indoor
walls. Operation takes place using
an infrared remote control.
The outdoor component consists of
a refrigerant circuit with compressor,
fin condenser, condenser fan,
reverse flow valve and throttle
element. The outdoor component is
controlled via the regulation of the
indoor unit.
The indoor unit consists of a fin
vaporiser, vaporiser fan, regulation
system and condensation pan.
Floor consoles, wall consoles,
refrigerant pipes and condensation
pumps are available as accessories.
5