REMKO ML 262 DC Arctic - Manual (Page 12)

There are individually adjustable
fins for adjusting the horizontal air
distribution on the air discharge
side.
Manual air distribution
Moving, internal parts, e.g.
fans, have the potential to
cause injury during operation!
Only make adjustments after
swing operation has been
switched off.
ATTENTION
Shift lever left
Manual air distribution
Shift lever right
Decommissioning
Temporary
Decommissioning
1. Allow the indoor unit to run for
2 to 3 hours in air circulation
mode or in cooling mode at the
maximum temperature setting
in order to remove any residual
moisture from the unit.
2. Shut down the unit using the
remote control.
3. Switch off the voltage supply to
the unit.
4. Cover the unit as far as possible
with plastic foil in order to
protect it from the influences of
weather.
Care and maintenance
Regular care and maintenance
serves to ensure trouble-free
operation and long service life of
the unit.
Care
■ Ensure the indoor unit and
outdoor component are
protected against dirt, mould
and other deposits.
■ Clean the equipment using
a damp cloth. Do not use any
caustic, abrasive or solvent-
based cleaning products.
Do not use a jet of water.
■ Clean the fins on the indoor
unit and outdoor component
prior to long shutdown periods.
Prior to performing any work,
ensure the equipment is
disconnected from the voltage
supply and secured to prevent
accidental switch-on!
ATTENTION
Permanent
Shutdown
Ensure that equipment and
components are disposed of in
accordance with local regulations,
e.g. through authorised disposal
and recycling specialists or at
collection points.
REMKO GmbH & Co. KG or your
contractual partner will be pleased
to provide a list of specialist
companies near you.
Maintenance
■ We recommend
concluding a maintenance
contract with annual service
from an appropriate specialty
company.
This ensures the operational
reliability of your system!
TIP
Statutory regulations require
an annual leak test for the
refrigerant circuit in relation to
the refrigerant filling capacity.
Inspection and documentation
is to be carried out by special-
ty technicians.
NOTE
REMKO ML...DC - ARCTIC
12