REMKO ML 262 DC Arctic - Manual (Page 11)

SLEEP Button A programming function is activated using this button, which increases
the target temperature in cooling mode by 1 °C after one hour and by
2 °C after 2 hours. In heating mode, the target temperature is decreased
by 1 °C after one hour by 2 °C after 2 hours. The unit switches off
automatically after 8 hours.
TIMER Button
The activation and switch-off time can be programmed with this button.
The timer is activated and the time display is switched off by pressing
the Timer on or Timer off button. The timer display on the indoor unit
illuminates. The desired activation or deactivation time is set by pressing
the Timer On or Timer Off buttons. When the programmed time has
been reached, the device automatically switches on or off. If the indoor
unit is automatically switched on, the mode, temperature and fan speed
for the last setting are activated. Deleting the preset on and off time early
is carried out by pressing the ON/OFF button. The timer display on the
indoor unit goes out.
Timer On Timer On 3 sec.
TIMER ON Button
3 sec.
TIMER OFF Button
Timer Off Timer Off
This button activates the „frost protection function“, which sets the
nominal temperature in heating mode to 8°C. This function is used to gu-
aranteed frost protection in unsupervised rooms. When the FP function
is active, the device switches heating mode on and at 8°C switches it off
again. This serves to ensure that the frost protection limit is not reached.
If „FP“ mode is activated, this is indicated in the display.
Pressing „ON/OFF“,“MODE“, „FAN“, „TEMP
▲ ▼„TIMER ON/OFF“,
FP“ will quit the function.
“FP” Button
MODE FP
HEATING
OPERATION
11