Quantum Composers 9200 Series - Manual (Page 8)

Page 8 9200 Manual Version 1.6 | Quantum Composers
Back Panel
Indicators
A total of up to 8 separate LED indicators are included on the back panel of the 9200. The
following further details the type of indication they represent.

PWR Indicates the unit is powered on.

Channel A-D Indicates which channels are in the enabled state.

Active Indicates the armed channels are actively pulsing
(or waiting to be triggered).

Gate/Trig Indicates which mode the external input is in. If
neither is illuminated, the unit is in internally
triggered mode.
BNC Output Connectors
Standard BNC connectors are found on the back panel which output the pulses for their
respective channel.
USB
A “Standard B” female type USB connector is found on the back panel. This provides power
to the unit as well as communication (on standard units).
Run/Stop/Power Button
The Run/Stop button serves the dual purpose of both powering on/off the unit as well as
enabling/disabling the system output. It should be noted that only a short press is needed to
both turn on and arm/disarm the unit. The button needs to be pressed and he ld for
approximately 1 second in order to power off the unit. In the power off sequence the active
settings are saved and reloaded when the unit is power back on.
The following image represents the back panel of a 4 channel 9214. It should be noted that
the 2 channel 9212 does not have channel C or D output BNC’s.
Figure 3.2- 9214 Back Panel