Quantum Composers 9200 Series - Manual (Page 16)

Page 16 9200 Manual Version 1.6 | Quantum Composers
Basic Operation
The following steps must be carried out before communication with the 9200 may take place:

Ensure that the proper drivers have already been installed on the remote computer.
These drivers will need to be installed for the remote computer to interface to the 9200.
Reference the “9200 Setup  USB” section for more information on installing the proper
drivers.

Open the 9200 application by double clicking on the application which can be found on
the included CD.

Once the 9200 application recognizes the COM Port the 9200 is attached to , a
connection will be established, and communication may now be carried out.
System Section
The System Section of the 9200 application
only affects the 9200’s system parameters. As
shown below in Figure 6.2, the following system parameters may be altered:
Figure 6.2 –9200 Application: System Parameters

Pulse Mode: Changes the system’s output mode to Continuous, Single Shot, Burst, or
Duty Cycle.

Period: Sets the System’s T
0
period. Valid inputs are 200ns –1000s set in 10ns
increments.