Orion System VCM Component - Manual (Page 6)

Component & System Wiring 6
Notes:
1.) All wiring to be in accordance with local and national electrical codes
and specifications.
TB1
Connect To Modular
I/O Connectors
Located On Back
Of The System Manager
ENTER
CLEAR ESC
PREV NEXT
DOWN
UP
6 5 4
DEC
7
0
8
1 3 2
9
MINUS
-
STATUS
SETPOINTS
SCHEDULES
ALARMS
OVERRIDES
WHITE (T)
DRAIN WIRE (SHLD)
BLACK (R)
RED (24 VAC)
Line Voltage
Modular Service Tool
Connect To Optional
CommLink (When Used)
Modular System Manager
24 VAC
(6 VA)
CLEAR (GND)
GREEN (GND)
Mode Selection
ENTER
CLEAR ESC
PREV NEXT
DOWN
UP
6 5 4
DEC
7
0
8
1 3 2
9
MINUS
-
STATUS
SETPOINTS
SCHEDULES
CONFIGURATION
ALARMS
ON
OVERRIDES
BALANCE - TEST
Note: Either A Modular
System Manager, A
Modular Service Tool
Or A PC With Prism
Software Installed Can
Be Used To Program
And Configure The
Orion System.
Line Voltage
HVAC Unit Controller
24 VAC
(8 VA)
(1 MEG)
FILENAME
DATE: B. Crews
DESCRIPTION: PAGE
DRAWN BY:
Wiring & Connection Diagram
JOB NAME
03/13/06
O-System-Stand-Alone.CDR
Stand Alone System
1 of 3
SHLD
T
R
Typical Terminal Blocks. All
Wiring To Be T To T, SHLD (G)
To SHLD (G) & R To R
T G R
485
LOOP
Typical Stand Alone System
For Optional CommLink, Remote Link
And Computer Connections, See Page 2
Of This Drawing.
Stand Alone System Wiring