Nortec MH Series - Manual (Page 43)

Start Up | 40
Performance Data Screen
Power Limit = the manually configured capacity limit (see
Power Limit on page 52).
Capacity A = the current output of the MHTC.
Σ Output = The current output of the MHTC (Note same as
Capacity A).
Operating Hours Screen
Operating Hour = total operating hours of the MHTC.
Time to next mainten. Hour = remaining operating hours
before the next maintenance must be performed.
Clean Trigger 1 Screen
Displays the setting for the first trigger that will cause the
MHTC to perform a cleaning cycle to clean the media.
Information displayed depends on the setting of Clean Trg. 1.
Timer = clean at specific time of day
Periodic = clean after a fixed number of operating hours
Demand = clean after fixed number of weighted hours
Off = First trigger turned off.
(See Cleaning Triggers on page 53 for more information)
Clean Trigger 2 Screen
Displays the setting for the second trigger that will cause the
MHTC Reflow to flush the reservoir to control mineral buildup.
Information displayed depedns on the setting of Clean Trg. 2.
Cycle = Flush after fixed number of fill cycles.
μSSensor = clean when conductivity measurements exceeds a
configured limit (requires optional conductivity sensor).
Off = Second trigger turned off (not recommended).
(See Cleaning Triggers on page 53 for more information)
Box Drying Screen
Displays the setting for when the media boxes will be dried.
Information displayed depends on the setting of Stage Drying:
Timer = Box drying will occur at specific time of day.
Periodic = Box drying will occur after a fixed number of
operating hours.