NewTek TriCaster Advanced Edition Automation and Integration Guide - Manual (Page 57)

45 | P a g e
For example:
Delay (ms) Shortcut Value Key 1 Value 1
.0001 net1 clip_store index AAA1
The entry above will ‘remember’ the current clip with the name “AAA1”. (The default for ID is an empty
string, which is a valid storage target.)
C
LIP
_R
ESTORE
Delay (ms) Shortcut Value Key 1 Value 1
(ms) net1 or net2 clip_restore index ID
This command cues up content previously stored with a specified ID value on the upstream source channel
assigned to the network input designated.
For example:
Delay (ms) Shortcut Value Key 1 Value 1
.0001 net1 clip_restore index AAA1
The clip previously indexed as “AAA1” (using clip_store) is restored on the source system output channel
connected to Net 1. The playhead is set to the beginning of the clip. (If the indexed clip is not located,
nothing occurs.)
C
LIP
_ S
ELECT
Delay (ms) Shortcut Value Key 1 Value 1
(ms) net1 or net2 clip_select index #
Select a page (or clip) defined by the value assigned to index. This may be a number specifying a particular
page or at times, another property.
For example, sending a “clip_select” command to 3Play with a suitable numeric value assigned as the
“index” key selects a specific Play List tab by index (assuming Play List mode is active. On the other hand,
in Clip List mode, if the value for “index” was “0-023” the clip referred to would be selected.
For example:
Delay (ms) Shortcut Value Key 1 Value 1
.0001 net1 clip_select index 4
This would select the fourth Play List tab on the 3Play output (A or B) connected to Net 1.