NavCom StarUtil-2110 Rev.B - Manual (Page 35)

StarUtil-2110 User Guide – Rev. B
B0 – Raw Measurements
‡
This message must be scheduled for output to view data. If not scheduled, select
Receiver > Messages > NCT output from the menu bar. The NCT Binary
Messages window opens. Add this message to the output list (see Figure 19).
1 2 3
4 - 9
10
Figure 27: B0 – Raw Measurements
1. Week: GPS Week number (Refer to the SF-2110 Technical Reference Manual)
2. Time: GPS Seconds into the week (Refer to the SF-2110 Technical Reference Manual)
3. SV Count: The number of GPS satellites currently tracked by the receiver.
4. Ch: The channel number of the receiver.
5. SV: The GPS or WAAS satellite number assigned to that particular channel. The valid GPS
PRN range is 1-32. The valid WAAS PRN range is 120-138.
6. C/NO: Carrier-to-noise ratio. The signal strength indictor.
7. CA: Coarse Acquisition code. The number of meters (range measurement) to the satellite.
8. L1: The number of carrier cycles between the satellite and the receiver.
9. Doppler: The fractional equivalent of the Doppler frequency. (Refer to the SF-2110 Technical
Reference Manual. The Doppler values are calculated from Wn4 in the 0xB0 message.)
10. Last: Shows the MM:DD:YYYY and HH:MM:SS of the last 0xB0 message update.
4-33