NavCom StarUtil-2110 Rev.B - Manual (Page 14)

StarUtil-2110 User Guide – Rev. B
1-12
StarUtil-2110 Main Functions
„ Configure
Rover
Configure the navigation mode, navigation rate and other operational options, such as elevation
mask and 2D/3D solution mode, for the rover. Refer to
Chapter 3 Configure Rover .
„ Setup Message Output Lists
StarUtil-2110 provides the user with two windows to schedule and configure messages for
output according to application requirements:
9 NCT Binary Messages Window (see Figure 18)
9 NMEA Messages Window (see Figure 33)
‡
The SF-2110 Technical Reference Manual (TRM) details all NCT binary
messages that can be output from the receiver.
„ View Message Output
9 View Menu: provides access to output of common NCT Binary Messages (see Figure 24)
9 NMEA Viewer: view output of scheduled NMEA Messages (see Figure 39)
„ Log Message Output
9 Log Data to File Window: log the data from scheduled NCT Binary Messages continuously
in a single file or in 24-hour data file splits (see Figure 38)
9 NMEA Viewer: log the data from scheduled NMEA Messages (see Figure 40)
„ StarFire Operation
Load or cancel the license for the StarFire subscription service. StarUtil-2110 also provides
functions and data pertinent only to StarFire enabled receivers. Refer to
Chapter 6 StarFire
Operation .
„ Load Software
Load purchased software options and/or free software updates to the SF-2110 receiver. Refer
to
Chapter 7 Load Software .
Configuration Reset
Select Receiver > Commands > Configuration Reset from the menu bar to reset the SF-2110
receiver to factory default settings. This command does not reset the position, time, almanac,
and ephemeris, but resets all other user settings to the factory default.