MovinCool CM25 Service Manual - Manual (Page 71)

Repair Section
71
7.3 Removal of Evaporator Fan Assembly
< NOTE >
Initialization is required after replacing the evaporator fan motor. (See page 61)
1) Take out the screw, and the four (4) nuts.
2) Disconnect the motor connectors (white, 5-pin
and white, 4-pin) from relay board CN3, CN4,
and remove the evaporator fan assembly.
I003127
Frame
Frame
Fan Motor
Ring
Fan
Set Screw
I003128
Nuts (4)
Screw (1)
Evaporator Fan
Assembly
ILL00247-01
1 6
CN4
Relay Board
CN3