Metro Mobile Computing Workstations MPS-4007 Lithium Ion Nano-Phosphate Power Supply - Manual (Page 45)

Metro TM MPS-4007 Li-Nano Power Supply Operations Manual Supplement, Doc. L01-505 45
InterMetro Industries Corporation
Disconnecting the Power Supply Batteries for Shipment
Notice: The following procedure for Disconnecting the Power Supply Batteries
applies only to Metro
TM Series Mobile Computing Workstation equipped
with the Li-Nano Power Supply (MPS-4007). The battery cells must not
be connected during shipment due to USDOT AND IATA regulations.
The procedure is required when preparing to ship an MPS-4007 Power
Supply or a Metro
TM Series Mobile Computing Workstation equipped
with the Power Supply.
Caution:
Only qualified service personnel should perform the following procedure
for Disconnecting the Power Supply Batteries.
Ensure Power
Supply is off • Ensure the AC cable is disconnected from the wall outlet and
Normal Operation/Extended Storage switch of the Power Supply is
in the Extended Storage (Standby: down) position (see procedure
above in “Connecting the Power Supply Batteries”).
Open the Battery
Connector Access
Panel • Open the Battery Connector Access Panel as detailed above in
“Connecting the Power Supply Batteries.”
Disconnect the
Battery Cells. • At each connector, slip a large flat head screwdriver under the latch
of the connector offset to the left as shown below.
Slip a large flat head screwdriver under connector latch