Is-0391 rev. e – Legrand AU7394-XX User Manual

Page 5

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com

Page 5 of 8

INSTRUCTION/INSTALLATION SHEET
lyriQ™ Standard Keypad

IS-0391 REV. E

control). Their IR /Status LED also blinks orange.

In this mode, all functions performed on the local keypad such as Volume Up/Down, Mute, Source selection, or
Power Up/Down are relayed to and performed on all active keypads in the system.

NOTE: There are also two special SOURCE commands that may be issued In this mode as described
below.

1) When in Whole-House Source Control Mode and the SOURCE button is pressed and held, a command will

be issued for all keypads to turn on and go to the selected source.

2) When in Whole-House Source Control Mode and the SOURCE button is double tapped, a command will be

issued for all active keypads to go to the source that the local keypad is currently on. This is handy to get
everyone sync’d to the same source without going through all the selections. Remember, if I’m listening to a
source let’s say #3 for example and want to perform Whole House commands to get everyone else there, if I
simply go into Whole-House Source Control mode and press the SOURCE button it will cause everyone to
go to #4 and then #1 and then #2 and finally to #3, while double tapping it will cause every active keypad to
go directly to Source #3.

NOTE: The Whole-House Source Control mode will be exited when the user fails to press a key within 10
seconds or by pressing and holding the MUTE and SOURCE buttons simultaneously as before.

5. Important Safety Precautions:

READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING THE lyriQ™ AUDIO SYSTEM.

• Do not attempt to service, move or change any component of this system unless you are qualified to do so.

• This system should be installed by a qualified installer and must conform to all local building and electrical codes.

• Do not apply power to the lyriQ™ Audio System until all components are installed and wiring has been properly terminated.

• Do not attempt to terminate, change or un-install any wiring without first turning off power at the lyriQ™ Audio System which

is located in the enclosure. Unplug the power transformer/s that is/are powering the lyriQ™ Audio System from the power
outlet before proceeding with wiring terminations or changes.

• Install all component of this system away from heat sources such as HVAC ducts/registers, stoves or any other heat source.

• Do not expose any component that was designed for indoor use to moisture. Doing so can create electrical hazards or

render the component unusable. Exposure to moisture will also void the warranty on the system.

• Do not use vacuum cleaners, liquid or aerosol cleaners to clean any of the system components.