beautypg.com

Is-0391 rev. e – Legrand AU7394-XX User Manual

Page 4

background image







301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com

Page 4 of 8

INSTRUCTION/INSTALLATION SHEET
lyriQ™ Standard Keypad

IS-0391 REV. E

©Copyright 2009 by Legrand All Rights Reserved.

 

 

4. Operation

A. ON/OFF:

Keypad – Press any button for ON / Press and hold MUTE
button for OFF (see Figure 5).

Remote – After pressing On-Q button, press On/Off button to
toggle ON or OFF (see Figure 6).


B. SOURCE

select:

Keypad – Press SOURCE button multiple times (see Figure 5).

Remote – Press SOURCE UP or DOWN button to select desired
source.(see Figure 6).


NOTE: Upon source change, volume ramps down and then
back up automatically.

C. Volume Steps: Keypad or Remote – Press VOLUME UP or DOWN button

(40 steps for Keypad / 36 steps for Remote).


D. Mute: Keypad or Remote – Press MUTE button to toggle On or Off.

E. Back Light Level Adjust:

Keypad – Press and hold VOLUME UP and DOWN buttons simultaneously. The
button back lights will flash to indicate they may be adjusted. Press VOLUME UP
or DOWN button to adjust back light level. Press SOURCE or MUTE button to exit
or wait for 10 second time out (see Figure 5).

NOTE: When any Keypad button is tapped, back light level goes to full bright and
returns to the adjusted level when activity ceases. For Remote operation, the
back light goes to full bright when an IR command is received and returns to the
adjusted level when activity ceases.

F. Temporary Do Not Disturb (DND):

Keypad – Double tap MUTE button, Status/IR LED glows dim RED (see Figure 5).

NOTE: When Keypad is in temporary DND mode, it will NOT respond to whole
house commands from other locations. Press any button to disable temporary
DND mode.

G. Whole-House Source Control/Party Mode (see Figure 5 and 6):

NOTE: In this mode, every operation performed on this keypad will be
relayed to all keypads in the system.

Keypad – Press the MUTE and SOURCE buttons simultaneously and the
IR/Status LED should blink orange (just press Whole House button on
Remote to toggle function On or Off.).

NOTE: The other keypads that are on and not in DND mode momentarily
flash their Volume Bar Graph LEDs (indicating they are under Whole House

Figure 5

Figure 6

Source
LEDs

Source

Button

Mute

Button

Volume
Buttons/
LEDs

IR

Target

Status

LED

On-Q

Button

Source
Buttons

Volume
Buttons

Mute

Button

Whole
House
Button

Room
Button

Local

Button

i Button

On/Off

Button