Datamax 123 Print v1.1x - Manual (Page 29)

Copyright © 2007 • MCL Technologies • All Rights Reserved
www
.mcl-collection.com
Chapter 2 : Getting Started
Assign Com 2 Printer Port To
ƒ This option is identical to the Assign Com 1 option. This option
simply lets you simulate a peripheral, such as a weight scale,
that would normally be connected to port 2 on the printer.
3 Select the desired option for printer port 2 simulation
Assign Internal Printer Port To
ƒ This option allows you to simulate label printing when you are
running your project in simulation.
ƒ You can emulate the label print or send the label as output to a
port on your development PC.
ƒ The output may be sent to a serial com port, an LPT (parallel)
port, or to a file. Sending the output to a file is useful if you
want to see the DPL code your project is using to print labels
on your printer.
The internal printer port simulation options are as shown below
4 Select the desired option for label printing simulation
5 Click OK
October 2007 Page 29