Datamax 123 Print v1.1x - Manual (Page 190)

Copyright © 2007 • MCL Technologies • All Rights Reserved
www
.mcl-collection.com
Chapter 7 : Deploying a Printer Project
7.3. Printer Control
General introduction 123 Print allows you to easily control a printer remotely / centrally.
This section describes these controls and how they are initiated.
Printer controls The following printer controls are available in 123 Print:
Feed Label
Pause Printer
Cancel Printing
Insert Test Label
Print Config Label
Reset Printer
Send Date Time
Reprint Last Label
Print Label
Load File / Control
Connect to a printer to enable these controls. If no printer is connected,
these controls are not active and the control icons are grayed out.
Many of these controls are also available via the physical printer’s front
panel or printer menu. Consequently, you may also refer to your
Datamax user manual for more information about these printer
controls.
To control a printer, on the 123 Print menu bar
1 Connect to a printer as described in Section 7.1 Connect /
Disconnect Printer
2 Click Control
3 Click the control you want to execute
Alternatively, click the desired control on the tool bar
October 2007 Page 190