K-Patents PR-01-S - Manual (Page 49)

INSTRUCTION MANUAL FOR K-PATENTS PR-01-S (-AX/FM/CS) DOCUMENT/REVISION No. INM 1/14
Effective: May 15, 2009
47
Code Diagnostic message Cause
0 Normal operation No fault
0 In divert control operation No fault
0 Removed from divert control No fault
Process related faults
Priority Code Diagnostic message Cause
1 1 Retrying wash Prism wash attempt failed
2 2 Solids warning Solids below warning limit
3 3 Solids alarm Solids below alarm limit
4 23 Wash stop / Temp. limit Temperature below set limit
5 4 Low concentration / no sample Whole image bright
6 6 High process temperature Temperature above set limit
7 21 Low light intensity Image nearly dark
8 22 Dip in image Optical image not correct
9 7 High conc / prism coated No shadow edge in image
Equipment malfunctions
Priority Code Diagnostic message Cause
10 28 Wash stop / ext. stop Input switch activated for wash stop
11 5 Prism wash failure Wash fault after retries
12 8 External output failure No response from output unit
13 9 Relay unit fault No response from relay unit
14 10 Divert control fault No response from divert unit
15 11 Temperature measurement fault Temperature out of limits
16 12 Prism coated / LED fault Light intensity too low
17 13 Not in line In line switch contacts open
18 24 High internal humidity Sensor internal humidity too high
19 25 High internal temperature Sensor internal temp too high
20 14 Detector timeout No signal from image detector
21 15 Sensor transmission error Noisy signal from sensor
22 16 No sensor signal No signal from sensor
23 17 Wrong concentration parameters Makes R.I. outside range
24 18 Constants error Wrong EPROM parameters
25 19 Sensor interface fault Fault on processor card
26 20 EEPROM write error Fault on processor card
Phase codes
Code Diagnostic message Cause
0 Blank Normal operation
1 Wait Wash permit wait
2 Precondition Preconditioning
3
Precondition Precondition / wash wait
4 Wash Wash
5 Recovery Recovery from wash
6 Hold Hold after external wash
Table 6.30
PR-01-S messages.