K-Patents PR-01-S - Manual (Page 33)

INSTRUCTION MANUAL FOR K-PATENTS PR-01-S (-AX/FM/CS) DOCUMENT/REVISION No. INM 1/14
Effective: May 15, 2009
31
Error status: For program versions from 4.0 the error status codes are:
Code Priority Error status
0 0 No errors
Process disturbances:
1 1 Retrying wash
2 4 Solids warning
3 5 Solids alarm
4 7 Low concentration / no sample
5 13 Prism wash failure
Malfunctions:
6 8 High process temperature
7 11 High conc / prism coated
Instrument malfunctions:
8 14 External output fault
9 15 Relay unit fault
10 16 Divert control fault
11 17 Temperature measurement fault
12 18 Prism coated / LED fault
13 19 Not in line
14 20 Detector timeout
15 21 Sensor transmission error
16 22 No sensor signal
17 23 Wrong concentration parameters
18 24 Constants error
19 25 Sensor interface fault
20 26 EPROM fault
From version 5.0, process disturbances
21 9 Low light intensity
22 10 Dip in image
23 6 Wash stop / Temp. limit
From version 6.0, process disturbances:
24 2 High internal humidity
25 3 High internal temperature
From version 6.0, instrument malfunctions:
26 12 Wash stop / ext. stop
Checksum: The checksum is the arithmetic sum of ASCII codes in columns before the checksum field.
For programs until version 3.1 the range is columns 1 to 65. For programs from version 4.0 the range is
columns 1 to 67. Least significant 7 bits are taken into the sum: the parity bits are zeroed.
Record terminator: The record is terminated with ASCII characters CR (0d hex) and LF (0a hex) to make
the record a text line.