Kawai ATX2/ATX2-f - Manual (Page 112)

112
Ap
p
e
n
d
ix
Troubleshooting
 USB (memory device)
Issue Possible Cause and Solution Page no.
A USB memory device is not detected, cannot be
saved to, or does not appear to function when
connected to the ‘USB to Device’ port.
Check that the USB memory device is formatted to use the FAT/FAT32
fi lesystem, and not set to ‘Write Protect’ mode.
p. 110
Disconnect the USB memory device, turn the instrument off then on, then
reconnect the USB device. If the USB device still does not function, it may
be damaged or incompatible. Please try using a diff erent USB device.
–
The instrument pauses briefl y when connecting
a USB memory device.
This is recognised behaviour when using very large capacity (e.g. 8GB+)
USB memory devices.
–
 MP3/WAV/SMF fi les
Issue Possible Cause and Solution Page no.
No sound can be heard when playing an MP3
or WAV audio fi le stored on a USB memory
device.
Check that the USB Recorder volume is not set too low. p. 47
Check that the format of the audio fi le is supported and listed in the
‘Audio Player supported format specifi cations’ table.
p. 46
An MP3/WAV audio fi le stored on a USB
memory device sounds strange, or does not
play back correctly.
Check that the format of the audio fi le is supported and listed in the
‘Audio Player supported format specifi cations’ table.
p. 46
The fi le transfer speed of the USB memory device may be too slow to
play the audio fi le. Please try using a diff erent USB memory device,
ensuring that it conforms to USB2.0 Hi-Speed standards.
p. 110
When recording MP3/WAV audio fi les, the
volume is too low/too high (distorted).
Check the gain setting before recording the audio, and if necessary
adjust to increase/decrease the recording level.
p. 44
An SMF MIDI fi le stored on a USB memory
device sounds strange when played back.
The AnyTimeX2 piano does not contain the full General MIDI sound
bank selection. Consequently, some SMF song fi les may not be
reproduced entirely accurately when played through the instrument.
p. 49