Harken 7412.13 12V MKIV Electric Jib Reefing & Furling - Manual (Page 6)

Preassembly Rigging Parts Check/Tools/Adhesive
Tools You Will Need
MKIV Furlers are shipped with 3M ® 5200
adhesive. Use adhesives on dry connectors
and foils using the special injection system
described in the assembly section. Parts
may immediately be exposed to rain. Cure
is best at 70 F (22C) with 50% humidity.
Do not apply at temperatures below 40 F
(5C) and above 100F (38C).
Although adhesive has not cured it will
remain in place on foil joints whether
they are left on the ground or raised up
on boat. Foils can be raised immediately
after assembly and sails fitted.
Note: A small amount of adhesive may
bulge out of injection ports. If possible
let system sit for a couple days before
sailing. If adhesive gets on sails remove
using acetone. For faster-curing adhesive,
purchase 4200 Fast Cure.
Note: Damaged foils can be repaired.
Use a hand-held propane torch to heat
joints until foils can be pulled apart.
Adhesive Alert
6 MKIV Unit 2E, 3E
1. Long tape measure 6. Side cutters 11. Center punch
2. Short tape measure 7. Rat-tail file 12. Rigging or black tape
3. Power drill 8. Hex keys (provided) 13. Scissors
4. Drill bit – 5/32" (4mm) 9. Slotted/phillips screwdrivers 14. Metal straight edge
5. Hacksaw 10. Needle-nose pliers 15. Hammer
16. 5 mm Ball-end hex key wrench (recommended but not required)
10
13
12
11
8
7
6
5
3
2
1
15
4
14
9
1. Harken jaw/jaw toggle and link plate assembly required. Sold separately.
2. Mating turnbuckle components, with eye at lower end, must be purchased
separately. See page 8.
3. Headstay may require cutting and shortening to fit Harken toggle. Some
headstays may remain uncut by replacing lower stud of turnbuckle with
stud/eye thus eliminating extra toggle.
4. Rod rigging requires Harken rod adapter stud.
Toggles
WARNING! Wire that is old or damaged may break suddenly,
causing an accident. Headstay condition should be checked
by a professional rigger before reusing.
ROD RIGGING
Harken Rod Adapter
Stud Required
(Sold Separately)
Harken Toggle/
Link Plate Assembly
(Sold Separately)
Unit Part No.
3E
7413.22 3/4
7413.22 7/8
16
Unit Part No.
3E
7426 -22
7427 -30
Rod Adapter Stud
Unit Part No.
2E
7312.22 5/8
7413.22 3/4
Jaw/Jaw Toggle
w/ Link Plate Unit Part No.
2E
7424 -12
7425 -17
7426 -22
5. Harken 7406 through-deck fitting for routing power wires through the
deck. Fits 1 /
2
" ID parker hose supplied with unit. Includes three (3) 6 mm x
35 mm fasteners and hose clamp. See page for template.
7406 Aluminum
through-deck fitting
for routing wires
belowdecks