Harken 7412.13 12V MKIV Electric Jib Reefing & Furling - Manual (Page 19)

Assembly Foils/Connectors
MKIV Unit 2E, 3E 19
Tighten screws into connector holes. Make
sure a drop of adhesive entered each screw
hole. If not, apply to screw.
Use “ml”
marks to
estimate 1
to 1 1 /
4
ml of
adhesive Stop when you see a small
amount of adhesive enter
one screw hole.
Inject only a small amount of adhesive
into middle hole.
Tip: When you see a small amount
of adhesive enter one screw
hole, stop. You have applied
enough adhesive.
Unit Adhesive (ml)
2 3 /4 – 1
3 (3/4, 7/8) 1 – 1 1 / 4
Unit Adhesive (ml)
2 3 / 4 – 1
3 (3/4, 7/8) 1 – 1 1 / 4
Use bushings, connector, wedge and
adhesive in other screw hole and insert
into other foil. Use adhesive (see chart
below for amount).
Red Loctite ®