Harken 7412.13 12V MKIV Electric Jib Reefing & Furling - Manual (Page 18)

18 MKIV Unit 2E, 3E
Hold plastic wedge in place with thumb
as you insert into foil. Line foil holes
with connector screw holes.
Assembly Foils/Connectors
Tip: In cooler weather, keep sealed
adhesive in pocket to keep warm. Use
instructions below to fill injector less
than half way; you will only use a small
amount of adhesive. Refill if needed
but do not keep open sealant for long
periods. Use adhesive within 3 hours.
Use cap of adhesive to break seal. Remove
injector tip cap and plunger. Hold injector
at an angle with applicator tip facing down.
Squeeze adhesive into tube so lower half
of injector is full as shown. Keep tip free
of sealant to let air inside.
Loading Injector with Adhesive
Adhesive in
lower half
Start plunger into injector and immediately
hold upright so plunger is down and
applicator tip is up.
As sealant runs down towards plunger an
air pocket will form near tip. Push plunger
to evacuate air. You are now ready to begin
injecting adhesive.