Guralp Systems CMG-CD24S6EAM - Manual (Page 8)

CMG-CD24S6EAM Introduction
2.3 System Architecture
2.3.1 Acquisition units
The primary system architecture of the acquisition units are given in the
figure below. Not all input and output ports are shown, these are listed in
section 2.2 on page 2.
The A and B inputs are analogue signals from attached seismometers as
shown in the next section.
Configuration and control of the Lantronix Wi-port NR and a CMG-EAM
modules is carried out via the web interfaces as detailed in section 3 on page
7.
Configuration and control of the digitisers is carried out via the EAM web
interface. The EAM also provides power to the CD24 digitisers.
For more information on the internal devices refer to the following manuals
available from the Guralp Systems website: www.guralp.com
MAN-EAM-0003 for the CMG-EAM
MAN-C24-0001 for the CD24
For more information on the Lantronix WiPort NR refer to the manufacturers
documentation:
www.lantronix.com/pdf/WiPort-NR_UG.pdf
MAN-C24-0003 5 Issue A - May 2011