Guralp Systems CMG-CD24S6EAM User Manual
Page 24
Appendices
7.
A WiPort NR entry should appear in the table on the right, denoting that
a device has been detected.
8.
If more than one WiPort NR entry appears, DeviceInstaller has detected
several devices.
9.
For every detected device, the program shows the Hardware Address (i.e.
the MAC address) and the IP address it is currently using. If you are
using a wireless router with a DHCP server, or an access point connected
to a network with a DHCP server, the device will use DHCP to assign it
an address. Otherwise, a random address will be chosen automatically.
Note: Automatic random addresses all begin with 169.254. The CD24
will choose a different one every time it is power cycled or rebooted.
10. The address of the CD24 may be shown in red with the status
Unreachable. If this happens, the sensor and PC cannot communicate
because they are not on the same subnet. Click Assign IP to start the IP
configuration wizard. Follow the instructions in the wizard to set the IP
address, or configure DHCP if you are using a DHCP server. When you
have finished, press F5 or use Device > Search from the menu system to
find the sensor with its new IP address.
Note: The IP address of the digitiser must have be on the same
subnet as the computer you want to connect to. The LAN
setting on the DeviceInstaller device tree identifies the IP
address of your computer. The first three number groups
typically need to be the same on all devices (digitisers and
computer).
11. If you want to configure the CD24 to use a static IP address, use the
Assign IP wizard as above and click Search again.
21