Guralp Systems CMG-CD24S6EAM - Manual (Page 10)

CMG-CD24S6EAM Setting up the CMG-CD24S6EAM
3 Setting up the CMG-CD24S6EAM
3.1 Initial Installation
Note: Refer to Appendix E on page 31 for information on connector
pinouts.
1. Connect the 10-pin connector on the unit to a GPS receiver using the
GPS cable. Position the GPS so that it has a good view of the sky. If you
do not have a view of the sky, you can operate the unit without a GPS
receiver, but timing information may be inaccurate.
2. Connect the instruments to the surge arrestors.
3. Connect the surge arrestors to to the 26-pin connectors in the
configuration shown in section 2.3.2 on page 6.
4. Use the power cable to connect the 10-pin Power/Data Out connector to a
fused 10 – 28 V power source and wait for the system to boot. This can
take up to 90 seconds. The LCD display will indicate when the process
is complete.
5. The system is now fully operational and will already be producing data.
6. The acquisition units can be connected to a PC using a serial cable from
the 10-pin Power/Data Out port or over a network using the Ethernet
ports.
7. Data outputs from the EAM can be viewed using the Guralp Systems
Scream application. See the manual MAN-SWA-0001 for information on
using Scream.
Data outputs from the Lantronix WiPort NR can now be accessed using
suitable software.
3.2 Connecting to the Lantronix WiPort NR
The Lantronix WiPort NR has been pre-configured so there should be no
reason to change any of the settings. If however you wish to make any
changes the following procedure for connecting to the Lantronix WiPort NR
should be used:
1. Connect the acquisition unit to a DHCP enabled network and note the IP
address.
2. Enter the IP address into the address bar of an internet browser.
MAN-C24-0003 7 Issue A - May 2011