Guralp Systems CMG-CD24S6EAM User Manual
Page 28
Appendices
2.
If the digitiser is to be connected to a routed network, enter the address
of the default gateway in the same manner.
3.
At the netmask prompt, enter 0 if you are using normal (classful) internet
addressing. If you have a non-standard or classless addressing scheme,
enter the number of bits of the IP address to be used for network
identification. Note that this is not the standard way of specifying
netmasks; it is more akin to the /n modifier used in CIDR address
specification.
4.
When you have finished setting up the module, apply the new settings
by selecting option 9 Save and Exit. The module will re-boot with the
new settings in effect.
5.
Disconnect the power supply from the acquisition unit.
6.
Remove the RS232 cable from the 9-pin D-connector.
7.
Connect the 26-way IDE-connector to the digitiser.
8.
Install the top cover.
9.
Connect the sensors to the acquisition unit.
10. Connect the power supply to the acquisition unit.
25