G. service – Greenheck Microprocessor Controller (474706 IOM) TAP v1.04 June 2011 (ERCH, ERH, APEX, VER, ERT) User Manual
Page 20
20
DDC Controller for Tempered Air Products
T
his
screen
allows
The
user
To
quickly
enable
The
bms
To
conTrol
uniT
operaTion
.
This screen appears if the unit is equipped with a BMS communication card.
The factory default configuration is for a non-BMS controlled unit. To allow
the BMS to start/stop the unit, change set point and occupancy, alter the
parameters on this screen.
T
his
screen
allows
The
user
To
view
The
sTaTus
of
The
wriTable
bms
poinTs
.
View the status of each point to confirm BMS communication.
The Service Settings menu allows the user to change the default Service
Password (1000), save and restore default parameters, and adjust probe
values.
T
his
screen
allows
The
user
To
view
uniT
run
hours
,
and
alTer
seT
poinTs
for
mainTenance
.
Run hours: The amount of time in hours that the unit has been powered.
Set Point: The amount of running time in hours before a maintenance alarm
should occur.
Reset to Zero: Reset the measured amount of run time.
T
he
p
robe
a
djusTmenT
menu
allows
The
user
To
calibraTe
sensor
probes
wiTh
an
offseT
value
.
Similar screens are available for remaining sensor probes.
T
his
screen
allows
The
user
To
change
The
s
ervice
l
evel
password
(pw1)
T
his
screen
allows
The
user
To
save
and
resTore
The
defaulT
parameTers
sTored
in
memory
.
If the user would like to save their settings, move the cursor to the SAVE
position and change to YES. This will save all of the current parameters into
memory as Service Settings. If the user would like to restore to these values
at some point in the future, moving the cursor to the RESTORE position, and
selecting YES will restore the controller to the user saved defaults.
Unit BMS Control
Unit Start/Stop:
No
Temp Setpoint:
Local
Occupancy:
Input ID6
BMS Writable Points
TempSetpoint:
78.0°F
Start/Stop:
Stop
Reset Alarms:
No
Occupancy:
Occ
MAINTENANCE HOURS
SYSTEM
Run hours:
0000h
Set Point:
0000h
Reset to Zero?
No
Analog Input
Outside Temperature
Input B01
Offset:
0.0°F
Value:
70.5°F
User Default
Insert new service password
(PW1):
1000
User Default Settings
Save?
No
Restore?
No
G.
Service
d. Service Settings
a. Working hour set
b. Probe adjustment
b. Password/Defaults
®