Gasboy 1000 Series FMS Card Encoding Manual - Manual (Page 37)

03/07/03 8-1
Section 8
CARD EMBOSSING
The cards can be embossed with information (e.g., card number, account number, etc.) to visibly
identify the card. On mag stripe cards, any area below 1 inch from the top of the card that
encompasses the mag stripe may be embossed. On optical cards, any area below 1
1/4 inch from
the top of the card containing the punched holes may be embossed.
An electric card embosser is available from GASBOY (P/N C02220). Please refer to the operating
guide provided with the embosser for proper use.
If you are having your cards encoded by GASBOY, you may also specify information to be
embossed on the card. In the order information section of the Card Encoding Form, indicate the
information to be embossed.