Gasboy 70 Series Installation - Manual (Page 16)

Startup and Operation Daily Operation
Page 12 MDE-4673 Consumer Electric Pumps Installation / Operation / Parts Manual · May 2007
Calibration
Calibration
Daily Operation
To begin the fueling operation, proceed as follows:
1 Remove the nozzle from the boot and turn on the pump handle.
2 Reset the register to zero if your model has a register.
3 Dispense fuel.
4 Turn the pump handle off. The amount delivered is displayed on the register.
The pump motor is equipped with thermal overload protection. If overheated, this will shut
itself off if there is not an additional external protection circuit which trips earlier. Ensure that
you turn off the pump power if this occurs. As the motor cools, it will start without warning if
power is on.