Gasboy ADDS 4000 - Manual (Page 8)

Installation of the ADDS 4000 Terminal and Okidata Printer
Page 8 MDE-4604 ADDS 4000 Terminal and Okidata® Printer Installation Instructions · February 2007
6 Press F5 or ENTER. The KEYBOARD1 menu setup screen appears.
7 Set the Print Scrn Key parameter as specified below. Ensure that you use the correct parameter
setting for your software version.
• If you have Site Controller I, Site Controller II below version 1.0F, Series 1000, TopKAT
or "A" System, set the Print Scrn Key parameter to Aux On/Off. With the Aux On/Off
value, press PRINT SCREEN to toggle on the Print mode. With the Print mode on, the
Okidata printer acts as a logger and also prints all the operations performed in the
Command mode. To temporarily suspend the output to the printer, press PRINT
SCREEN. Press PRINT SCREEN again to resume the output to the printer.
Note: After the terminal is reset (power turned off and on), press PRINT SCREEN to
place the terminal in the Auto Print mode. Failure to do so will result in the data not
being printed on the printer.
• If you have Site Controller II version 1.0F or above, you may set the Print Scrn Key
parameter to Aux On/Off and configure the DIRECT PRINTOUT CHANNEL in
SYS_PAR to AUX-0. This parameter combination sends the printout directly to the
Okidata logger and is not seen on the Cathode Ray Tube (CRT) screen. Any commands
performed at the CRT are not logged unless either the output is directed to the logger
(using >log with the command) or you press PRINT SCREEN to toggle the output to the
logger.
Note: If the Okidata printer is connected directly to Site Controller II, configure the
DIRECT PRINTOUT CHANNEL in SYS_PAR to the port that is connected to the
printer and refer to C01918 Site Controller II Installation Manual for information
regarding connections (RS-232).