Okidata 184/186 setup, Sw1-1 to sw1-8, Sw2-1 to sw2-3 – Gasboy ADDS 4000 User Manual
Page 10: Sw2-4 to sw2-8
Installation of the ADDS 4000 Terminal and Okidata Printer
Page 10
MDE-4604 ADDS 4000 Terminal and Okidata® Printer Installation Instructions · February 2007
Okidata 184/186 Setup
To prepare the Okidata printer for operation with the ADDS 4000 terminal and your Gasboy
Fuel Management System, perform the following steps. Install and complete the setup of the
printer as specified in the manufacturer's setup instructions. Then, set up the switches as
follows:
SW1-1 to SW1-8
SW1
SET
Function
SW1-1
ON
Parity: Odd
SW1-2
ON
Parity: Without
SW1-3
ON
Data bits: 8
SW1-4
OFF
Protocol: XON/XOFF (Series 1000 V8.1 or higher, FleetKey V2.1 or
higher, CFN, or TopKAT)
ON
Protocol: Ready/Busy (Series 1000 versions prior to V8.1, FleetKey
versions prior to V2.1, and "A" Systems)
SW1-5
ON
Test select: Circuit
SW1-6
ON
Mode select: Print
SW1-7
ON
Busy line selection: DTR - Pin 20
SW1-8
ON
Busy line selection: DTR - Pin 20
SW2-1 to SW2-3
Baud Rate
SW2-1
SW2-2
SW2-3
9600
OFF
ON
ON
2400
OFF
OFF
ON
1200
ON
ON
OFF
300
ON
OFF
OFF
Note: Any change made to the baud rate must also be changed on the Aux Baud parameter on
the Boundless Terminal Communications setup screen
SW2-4 to SW2-8
SW2
SET
Function
SW2-4
ON
DSR output signal: Active
SW2-5
ON
Buffer threshold: 32 bytes
SW2-6
OFF
Busy signal timing: 1 sec (min.)
SW2-7
ON
DTR signal: Space after power on
SW2-8
OFF
Not used