Gasboy ADDS 4000 - Manual (Page 5)

MDE-4604 ADDS 4000 Terminal and Okidata® Printer Installation Instructions · February 2007 Page 5
Installation of the ADDS 4000 Terminal and Okidata Printer
Installation of the ADDS 4000 Terminal and Okidata Printer
ADDS 4000 Terminal Setup
Install and complete the setup of the ADDS 4000 terminal as specified in the manufacturer's
setup instructions. Then, enter the Setup mode and change the parameters available on the
screens. This enables the terminal to function properly with both the Okidata printer and your
Gasboy Fuel Management System.
When setting up the terminal, use the following keys as required:
Key Function
SHIFT and SysRq Used together to enter the Setup mode.
Up/Down Arrows Used to move to a menu item.
Left/Right Arrows or SPACE Used to select values for a parameter.
ENTER or SHIFT and ENTER Used to move to the next or previous screen.
First letter of section name Used to select a specific screen.
F1 to F11 Used to select a specific screen.
E and then Y Used to save current values and exit the Setup mode.
E and then SPACE Used to exit the Setup mode without saving the operation.
Note: In the procedure that follows, the setup parameter values shown in bold are critical and
must be configured as shown in this document. All other parameters can be configured
as per the user’s preference or left at their default value.
To install the ADDS 4000 Terminal Setup, proceed as follows:
1 Press CAPS LOCK to activate the caps lock feature. CAPS appears in the upper left hand
corner of the status line.
2 Press SHIFT and SysRqEnter to enter the Setup mode.
Note: Ensure that you do not press CTRL and SysRq as the terminal control will switch to
Aux Host. On being switched to Aux Host, press CTRL and SysRq to return to the Main
Host and display the EXEC1 menu.