Gasboy ADDS 4000 - Manual

MDE-4604 ADDS 4000 Terminal and Okidata® Printer Installation Instructions · February 2007 Page 1
Introduction
Purpose
This manual describes the parameters for the setup of the ADDS 4000 terminal and the printer
switch settings for the Okidata
® 184/186 printer when connected to a Gasboy Series 1000,
Series 900 TopKAT TM , Cash Flow Network (CFN), or an "A" Fuel Management System. This
document is not intended to be a complete reference for the Boundless terminal. The
parameter screens shown are the latest available. However, interim software changes by the
Boundless terminal may result in minor variations.
Review the documentation section on the Boundless website ( http://www.boundless.com ) for
clarifications.
Table of Contents
Topic Page
Introduction 1
Important Safety Information 3
Installation of the ADDS 4000 Terminal and Okidata Printer 5
ADDS 4000 Terminal Setup 5
Okidata 184/186 Setup 10
Required Reading
Before performing this installation, the installer must read, understand, and follow this
manual. Failure to do so may adversely affect the operation of the equipment.
Required Tools
The following tools are required for the installation of the ADDS 4000 Terminal and Okidata
printer.
• Phillips ® screwdriver
• Straight blade screwdriver
Parts List
The following table lists the parts required for this installation.
Description Part Number Quantity
Display Terminal, Boundless Technologies M07339B001 1
MDE-4604
ADDS 4000 Terminal and Okidata ® Printer
Installation Instructions
February 2007