Gasboy Sinclair Credit - Manual (Page 11)

Credit & Debit Card Networks Sinclair 015 3
Gasboy CFN Series
Running SINCLAIR
The program can be run in two ways: menu or command line.
Menu
To run the Sinclair program in the menu
mode type SINCLAIR, press , and
the main menu will appear.
The menu entries are described later in
this manual. Enter the number on the left to
execute the operation described. The
Options allow you to:
F - redirect the screen output to a
specific file.
S - have output go to the screen.
? - print the options for the command
line execution of the program
The default is to print output to the screen. When you have finished, select the 1. EXIT option to exit the
program.
Command Line
The command line format of the program is:
SINCLAIR option[s]
where the valid options are:
-? Print this help list
-E Allows user to edit Network Configuration
-C Edit Credit Card Acceptance table
-P Edit Instant-On Pump Table
-X Edit Product Cross Reference
-R <file> Loads SINCLAIR configuration from given file
-W <file> Writes current SINCLAIR configuration to given file
-K Remove Transaction from Batch
-S Prints current SINCLAIR configuration
-I Option resets current SINCLAIR configuration
The options can be combined, though some care must be used in combining some operations with the
read, write and initialize file options. The options are described later in this manual.
Saving Your Configuration
The program operates upon the FRAMOS.CFG file in your current directory.
The Read and Write commands allow you to save some of the information entered to a file. By reading
the file, you can then quickly restore your system to an operating state in the event the data is lost. The
information stored is that information not found in your FRAMOS.CFG file. This includes Sinclair
information such as Merchant ID, Store Number, etc. The phone numbers are not included.
To save your current setup, enter SINCLAIR -W filename.
You should copy this file and your FRAMOS.CFG file to a disk for safe-keeping. Should your system
ever lose its configuration, copy the FRAMOS.CFG and the network information file to your boot disk and
reboot. RUN SINCLAIR -R and enter the network information file name. After committing the information
to the Site’s memory and reentering the phone numbers you should again be ready to authorize cards with
SINCLAIR MAIN MENU
1. Exit
2. Edit Network Parameters
3. Edit Card Parameters
4. Edit Instant On for Pumps
5. Edit Product Cross Reference
6. Read Network Parameters from File
7. Write Network Parameters to File
8. Remove Transaction from Batch
9. Print Configuration
10.Initialize Network Parameters
Options: F = File, S = Screen, ? = Help
Output to : SCREEN
Your choice (#, f, or S)
ENTER