Gasboy Sinclair Credit - Manual (Page 10)

2 Sinclair 015 Credit & Debit Card Networks
Gasboy CFN Series
Setting Up Your Site
DO NOT set up Sinclair through SYS_PAR. You must set up the router using the follow steps.
Site Controller Setup
To set up your Site Controller for Sinclair:
1. Run TABLE and set the following:
Auth. Table - 75 (used for fleet cards)
Router Table - minimum 306
Price Table - add 50 if using discount pricing
2. Run SINCLAIR -I to initialize the network parameters.
3. Reboot.
4. Run SINCLAIR -E (or from the menu system, select Edit Network Parameters).
5. Select the main menu option, W, to step you through all of the basic data needed for the net-
work.
6. Run SINCLAIR -C to set the card parameters.
7. Run SINCLAIR -X to set up the product cross reference.
When all of the information is entered, write the parameters to a file and exit. A recommended name for the
file would be SINCLAIR.RTR. This file would be used if the parameters were erased and needed to be
reloaded. More on saving data on page 3.
Reader Setup
If you will be taking Fleet Cards, you must add the Enter PIN, Enter odometer, and Enter auxiliary number
fields before the Select pump step in the reader program. An example reader setup can be found on page 10.
Miscellaneous Setup Notes
You should get a message to run SINCLAIR -I after the system comes up. Memory Full will also probably
be displayed, this is normal. Run:
RUN;I
FIX TR;I
SINCLAIR -I
After SINCLAIR -I (Initialize) is run, the modem DTR light should come on and the RD and SD lights
should flicker indicating that the router is running and has initialized the modem.
If it’s a new installation, reset the batch number. Run:
SETTLE -R l
If your site is not dialing after card authorizations are attempted, check that:
1. The correct phone number is entered.
2. Lockout on Remote Verification parameter (SYS_PAR) for the reader and/or console is not
set to CREDIT.
3. The card is enabled for use with this site (SINCLAIR -C command).