Gasboy CFN Series SCII Installation Manual - Manual (Page 13)

CFN Series System
2-6 05/28/03
ISLAND CARD READER
Description
The island card reader is a rugged and well-designed data entry terminal that gives users access
to self-service gas pumps. The unit is controlled by a microprocessor and communicates to the
site controller via the RS-485 loop.
The unit is available with either an ABA Track 2 magnetic stripe card reader or an optical reader.
A 20-character liquid crystal display is used to guide the user through the transaction. The display
is backlit so that it can be read at night. A membrane keypad incorporates easy-to-read legends
and provides the user with the means to input data to the system.
Three different types of posts are available with the island card reader. The unit comes standard
with a blank post. This post is used for mounting the island card reader to the island. The island
card reader is also available with a receipt printer post or a pump control post.
Special Island Card Reader for CNG
A special version of the CFN Island Card Reader is available for use in the Class 1, Division 2
area of CNG sites (Model DETC). The dimensions of this unit are the same as those found in the
Island Card Reader with Blank Post drawing. This unit is not available with an internal receipt
printer or pump control unit.
Location
The island card reader should be located on the fuel island. The unit has been designed for an
operating temperature range of -40
o F to 104 o F with a relative humidity of 2% to 99% non-
condensing. Adequate clearance must be provided to allow easy access to the post’s access
covers. An island card reader with a receipt printer post or a pump control post requires a
minimum of 18 inches clearance between the post and any of the pumps/remote dispensers on
the island.