Gasboy M06184K00X - Manual (Page 9)

MDE-4487C Atlas™ Dispenser Vapor Recovery Kit (M06184K00X) Installation Instructions · September 2008 Page 9
Installing the M06184K00X Vapor Recovery Kit
3 Install Reel and Support Post Assembly to the side of the dispensing unit and loosely secure
with hardware (items
5 , 6 , 7 , 9 , and 10 ).
Note: The spacer (item 7 ) mounts between the post and side panel. On electronic models, the
spacer mounts to the side panel through a pre-existing plugged hole to the right of the
off-side lever stop. On mechanical models, the spacer mounts to the side panel
replacing the off-side lever stop.
4 Ensuring that the support post is plumb, mark and drill a hole of diameter 5/8 inch and depth
of 1-3/4 inch in the island.
5 Install Bolt Anchor (item 8 ) in the hole. Secure the bottom of the support post with hardware
(items 4 , 5 , and 6 ).
6 Tighten all hardware installed in step 3 .
7 Plug the hole in the bottom of the support post by installing the bottom plug (item 9 ).
Modifying Nozzle Boot
The following parts are required to modify the nozzle boot:
• 003336 - Nozzle Boot (electronic model) (item 19 )
~ OR ~
M05632B001 - Nozzle Boot (mechanical model) (item
19 )
• 003719 - Nozzle Hook Kit (item 20 )
• 026850 - Nozzle Boot Gasket (item 21 )
1 Remove the four screws securing the existing nozzle boot and remove the nozzle boot and
existing gasket. Save screws for reassembly.
2 Mount new Nozzle Boot Gasket (item 21 ) and Nozzle Boot (item 19 ) and secure with the
screws saved in step 1 ( Figure 3 on page 8 ).
3 Remove the hardware from the existing nozzle hook. Save all mounting hardware for
reassembly.
4 Remove the two plugs from the lower mounting holes of side panel and place them in the two
upper holes.
5 Install the new Nozzle Hook Kit (item 20 ) in the two lower holes in the side panel and secure
using mounting hardware saved in step 3 ( Figure 3 on page 8 ).