Gasboy M06184K00X - Manual (Page 10)

Completing the Installation
Atlas ™ is a trademark of Gilbarco Inc. Gasboy ® is a registered trademark of Gilbarco Inc. Teflon ® is a registered trademark of E. I. DuPont
de Nemours and Company. UL ® is a registered trademark of Underwriters’ Laboratories, Inc.
© 2008 GASBOY
7300 West Friendly Avenue · Post Office Box 22087
Greensboro, North Carolina 27420
Phone 1-800-444-5529 ·
http://www.gasboy.com · Printed in the U.S.A.
MDE-4487C Atlas™ Dispenser Vapor Recovery Kit (M06184K00X) Installation Instructions · September 2008
Mounting Hose to Retriever and Splitter
The following parts are required to mount the Hose to the Retriever and Splitter:
• 038502 - Emco VR Nozzle (item 12 )
• 030301 - GY Hose, 7.5 feet (item 13 )
• 044007 - Breakaway (item 17 )
• 030303 - GY Hose, 4.5 feet (item 18 )
1 Using white lithium-based grease, lubricate both ends of the 7.5-feet GY hose threads (item
13 ) and O-Rings.
2 Thread one end of the hose into the Emco Splitter ( Figure 2 on page 6 and item 14 , Figure 3 on
page 8 ) on the dispenser unit.
3 Thread the breakaway (item 17 ) on the other end of the hose.
4 Using white lithium-based grease, lubricate both ends of the 4.5-feet GY hose threads (item
18 ) and O-Rings.
5 Thread one end of the hose into the breakaway. Thread the Emco VR Nozzle (item 12 ) onto
the other end of the hose.
6 Tighten all connections securely (four connections).
7 Install the clamp on the Clamp and Reel Assembly (item 1 ) to the hose. Position the clamp on
the hose such that the hose does not touch the ground when the nozzle is positioned in the
boot.
8 Pull out the hose and check the operation of the Clamp and Reel Assembly retriever and also
check the lay of the hose.
Completing the Installation
1 Inform the Manager/Owner that power will be restored to the unit and then restore power
using normal procedures. Remove the lockout/tagout and return to normal operation.
2 Release the emergency shutoff valve.
3 Test the system for leaks. For detailed information regarding leak tests, refer to MDE-4334
Atlas Start-up/Service Manual.