beautypg.com

Mounting the hose retriever, Modifying nozzle boot – Gasboy M06430K00X User Manual

Page 11

background image

MDE-4522A Atlas™ Self-Contained Pump Vapor Recovery Kit M06430K00X Installation • November 2006

Page 11

Hose and Retriever Installation

Mounting the Hose Retriever

Items needed for this procedure are the following:

• Item 1 - 032671 Clamp and Reel Assembly
• Item 2 - 063838 Support Post
• Item 3 - 017930 1-1/2-inch Cap Plug
• Item 4 - 051956 5/16-18 x 2 SS Screw
• Item 5 - 068079 5/16-inch SS Washer
• Item 6 - 068874 5/16-inch SS Lock Washer
• Item 7 - 063200 Spacer, 3-1/4-inch
• Item 8 - 013250 5/16-inch Bolt Anchor
• Item 9 - Q10554-12 Bottom Plug
• Item 10 Q10624-23 5/16-18 x 4-1/4-inch Screw

1

Assemble Clamp and Reel Assembly (item 1) to support post (item 2) with hardware (items 4,
5, and 6) (

Figure 6

)

2

Install Cap Plug (item 3) in the top of the support post (

Figure 6

).

3

Install Reel and Support Post Assembly to the side of the dispensing unit and loosely secure
with hardware (items 5, 6, 7, 9, and 10) (

Figure 6

).

Note: The spacer (item 7) mounts between the post and side panel.

On electronic models, the spacer mounts to the side panel through a pre-existing
plugged hole to the right of the off-side lever stop.
On mechanical models, the spacer mounts to the side panel replacing the off-side lever
stop.

4

Making sure that the support post is plumb, mark and drill a 5/8-inch diameter x 1-3/4-inch
deep hole in the island (

Figure 6

).

5

Install Bolt Anchor (item 8) in hole. Secure bottom of support post with hardware (items 4, 5,
and 6) (

Figure 6

).

6

Tighten all hardware installed in step

3

.

7

Plug hole in bottom of support post by installing bottom plug (item 9) (

Figure 6

).

Modifying Nozzle Boot

Items needed for this procedure are the following:

• Item 19 - 003336 Boot, Nozzle (electronic model)

~ OR ~
Item 19 - M05632B001 Boot, Nozzle (mechanical model)

• Item 20 - 033719 Hook, Nozzle Kit
• Item 21 - 026850 Boot Gasket

1

Remove the four screws securing the existing nozzle boot and remove the nozzle boot and
existing gasket. Save screws for reassembly.

2

Mount new Nozzle Boot Gasket (item 21) and Nozzle Boot (item 19) and secure with the
screws saved in step

1

(

Figure 6

).